Place the new pickup roller onto the shaft. Release the roller by sliding apart the two latches located on each side at the top of the pickup roller simultaneously until the roller pops out free. Next lift the hinged small black plastic cover to access the cassette pickup roller. Remove the bottom toner cartridge by pulling it straight out the printer. You will need to first remove the bottom toner cartridge to get access to the cassette pickup roller. Slide the roller into the printer until the roller snaps into place. Align the pin that is located on each side at the bottom of the roller with the slot in the bracket located on each side of the opening. Once the separation pad assembly is slid in, Use a short Phillips with a #0 tip screwdriver to screw into place.
Install the new separation pad assembly into the printer by sliding it into the open slot for the pad. Once the screw is removed then slide the separation pad assembly out of the printer. Use a short Phillips with a #0 tip screwdriver to remove the separation pad’s screw.
Pry the small white tabs of the holder apart and the roller will pop out freely then remove it from the printer.īefore install the manual feed pickup you will need to first remove the separation pad that sits right beneath it. The Manual Feed Pickup Roller has two white tabs that have to be released simultaneously. Locate the manual feed pickup roller in the center of the open printer. Once the transfer belt assembly is unlocked remove it away from the printer. Pinch the small blue tabs simultaneously to unlock and release the transfer belt assembly. The transfer belt assembly has two small blue tabs on each side keeping the transfer belt assembly locked into place. Open the front door and fold down the transfer belt assembly. Slightly pull back on the fuser to check if it is secure. While holding the two blue fuser tabs - slide the back end first into the empty fuser slot in the printer and then rotate the front end down in place so that the blue locking tabs “SNAP” into place.
Install the new fuser by pinching the two blue fuser tabs in the direction of the blue arrows. While pinching the tabs, slightly rotate the fuser away from you and lift the fuser up and out of the printer. Locate the fuser and pinch the two blue fuser tabs in the direction of the blue arrows. Open the top cover by swing the door straight up. Turn the power off and unplug the power cord from the printer.Ĭaution if you have been using the printer the fuser section will be hot! Please allow the fuser to cool for at least 30 minutes before removing it. And One Short Phillips zero tip Screwdriver (PR# T4500)